Digital Output - Fuji Xerox DocuPrint M355df Service Manual

Chapter 6 General
6.6 IOT Diag

6.6.2 Digital Output

Checks whether the DO (digital output) components such as motors and clutches are functioning properly.
You can enable the test for each DO component and check the operation from the outside, which helps you
judge which component functions normally.
Digital Output Test allows you to operate all components at one time.
If the interlock is opened during a motor test, the operation of each component is stopped.
NOTE
Except for 010-001, 042-001, 042-002, and 042-003, set LVPS 24V (041-001) to ON (EXEC). Otherwise,
the component does not operate.
Chain
010
041
042
042
042
061
071
071
071
071
071
071
071
071
071
071
071
071
093
093
Table 6-40 Digital Output Test Parameter Table
Link
001 Fusing Relay
001 Low Voltage Power Supply 24V
001 Rear Fan (Normal)
002 Rear Fan (Half)
003 LVPS Fan
001 ROS Motor [Motor Polygon ASSY]
001 Main Motor [DRIVE ASSY MAIN] (Normal)
002 Main Motor [DRIVE ASSY MAIN] (Half)
003 Main Motor [DRIVE ASSY MAIN] (Low)
004 MSI Feed Solenoid [SOLENOID FEED MSI] (Auto OFF)
005 Tray 1 Feed Clutch [CST FEED CLUTCH]
006 Regi Clutch
007 Exit Clutch [CLUTCH ASSY EXIT]
008 Exit Invert Clutch [CLUTCH ASSY INVERT]
Option Feeder 1 Motor [MOTOR ASSY OPTION] (Nor-
009
mal)
010 Option Feeder 1 Motor [MOTOR ASSY OPTION] (Half)
011 Option Feeder 1 Motor [MOTOR ASSY OPTION] (Low)
Option Feeder 1 Feed Clutch [CLUTCH ASSY OPT
018
FEED] (Auto OFF)
001 Toner Dispense Motor [MOTOR DISP] (Normal)
002 Toner Dispense Motor [MOTOR DISP] (Half)
6-46
Component