Images Are Skewed - Fuji Xerox DocuPrint M355df Service Manual

IQ-19

Images are skewed

Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the error mode.
2
Does the error occur when feeding the original at the DADF?
Checking the original setting.
3
Is the original set to the platen glass correctly?
Checking the original setting.
4
Does the original meet the DADF spec?
Checking the DADF Guides setting.
5 Reseat the DADF Guides.
Does the error still occur when copying?
Checking the KIT DADF PICK UP MODULE.
6 Are there any damages or foreign substances on the KIT
DADF PICK UP MODULE?
Checking the paper feeding tray.
7
Is the skewed paper fed from the MSI?
Checking the side guides setting of MSI.
8 Reset the side guides.
Is the image printed correctly?
Checking the paper path.
9
Are there any foreign substances on the paper path?
10 Is the image printed correctly?
Check the paper feed rolls
11 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Chapter 3 Image Quality Troubleshooting
Possible causative parts
- IIT ASSY (PL21.1.14)
- DADF ASSY (PL21.1.1)
- KIT DADF PICK UP MODULE (PL21.1.95)
- ROLL ASSY RUBBER (PL15.2.6)
- ROLL ASSY REGI PINCH (PL15.2.8)
- ROLL REGI PINCH (PL15.2.37)
- Transfer Unit [ROLL ASSY-TRANS CRU] (PL6.1.1)
- Heat Roll [FUSING UNIT] (PL7.1.1)
Check and Action
3-39
3.2 Image Quality Troubleshooting
Yes
Go to step 2.
Go to step 4.
Replace the IIT
ASSY (REP
21.1).
Go to step 5.
Go to step 6.
Remove the for-
eign substances
or replace the
KIT DADF PICK
UP MODULE.
Go to step 8.
End of work.
Remove the for-
eign substances,
then go to step
10.
End of work.
Go to Step 13.
No
Go to step 7.
Go to step 3.
Reseat the origi-
nal.
Use the platen
mode or change
the paper type.
End of work.
Replace the
DADF ASSY.
(REP 21.1).
Go to step 9.
Go to step 9.
Go to step 11.
Go to step 11.
Reinstall the cor-
responding
paper feed rolls,
then go to step
12.