Iot Diag; Digital Input - Fuji Xerox DocuPrint M355df Service Manual

Chapter 6 General

6.6 IOT Diag

6.6 IOT Diag

6.6.1 Digital Input

Checks whether the DI (digital input) components such as sensors and switches on the IOT are functioning
properly.
Displays "0" when Digital Input Test is started. This value is increased when the DI components are switched
from OFF to ON, which is used for confirming that the component functions normally. Digital Input Test targets
all DI components.
Chain
010
010
041
041
042
042
071
071
071
071
071
071
Digital Input Test Example
This section contains an example of Digital Input Text using [041-300: Inter Lock Front Cover].
1 Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2 Confirm that [Printer Diag] is selected, and then press the [OK] button.
3 Use the [ ] button to select [IOT Diag], and then press the [OK] button.
Printer Diag
IOT Diag
Table 6-39 Digital Input Test Parameter Table
Link
200 Fusing Relay Enable
201 Fusing Fuse Open (invalid code)
300 Inter Lock Front Cover
301 Inter Lock Rear Cover
200 Rear Fan Alarm
201 LVPS Fan Alarm
100 MSI No Paper Sensor
101 Tray 1 No Paper Sensor [CST No Paper Sensor]
102 Regi Sensor
103 Exit Sensor
116 Option Feeder 1 No Paper Sensor
200 Option Feeder 1 Motor Alarm
6-44
Component
IOT Diag
Digital Input