Fuji Xerox DocuPrint M355df Service Manual page 437

Chapter 6 General
6.8 Installation Settings (Installation)
Item
Clear Auditron PV
Error Log
Jam Log
Job Log
FW Parameter
Clear Device
Data
(Clears the items
NET Parameter
on the right in the
order from top to
bottom.)
Auditron/PV
SRAM Adrs
FAX Log
Serial Number Setting (Serial No.)
The procedure below describes how to change the parameter using [Serial No.] as an example.
1 Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2 Confirm that [Printer Diag] is selected, and then press the [OK] button.
3 Use the [ ] button to select [Installation], and then press the [OK] button.
Printer Diag
Installation
4 Confirm that [Serial No.] is selected, and then press the [OK] button.
Installation
Serial No.
Table 6-42 Installation Settings
Range
Clears the Auditron PV data such as billing
counter, user account, and restriction informa-
- tion.
(Auditron PV can also be initialized using
[Clear All NVM].)
- Deletes the Error Log data in the EEPROM.
- Deletes the Jam Log data in the EEPROM.
- Deletes the Job Log data in the EEPROM.
Deletes the FW Parameter data in the
-
EEPROM.
Deletes the NET Parameter data in the
- EEPROM. (Only for models with network fea-
tures)
Deletes the EEPROM-stored print volume
-
data specific to Auditron/user.
- Deletes the address book data in the SRAM.
Deletes the FAT data of the system data file
- system for Fax and all files under that file sys-
tem within the SRAM/Fax Memory.
6-62
Description
Installation
Serial No.
Serial No.
000000 *