Fuji Xerox DocuPrint M355df Service Manual page 139

Chapter 3 Image Quality Troubleshooting
3.2 Image Quality Troubleshooting
Step
Checking after replacing the Transfer Unit.
10 Replace the Transfer Unit.
Is the image printed correctly?
Checking the Transfer Unit for connection.
11 Remove the Transfer Unit.
Are the Plate Spring BTR on HVPS dirty or deformed?
Checking after resetting the Transfer Unit.
12 Reseat the Transfer Unit.
Is the image printed correctly?
Checking the Drum Cartridge for connection.
Remove the Drum Cartridge.
13
Are the Spring BCR and Spring DB on HVPS dirty or
deformed?
Checking after resetting the Drum Cartridge.
14 Reseat the Drum Cartridge.
Is the image printed correctly?
Checking after replacing the Drum Cartridge.
15 Replace the Drum Cartridge.
Is the image printed correctly?
Checking after replacing the FUSING UNIT.
Replace the FUSING UNIT.
Is the image printed correctly?
Start the operation after the FUSING UNIT has cooled
16
down.
NOTE
After replacement, be sure to clear the life counter value.
Check and Action
3-10
Yes
End of work. Go to step 11.
Clean up the
Plate Spring BTR
or Replace the
Go to step 12.
HVPS (REP
18.3), then go to
step 12.
End of work. Go to step 13.
Clean up the
Spring BCR and
Spring DB or
Replace the Go to step 14.
HVPS (REP
18.3), then go to
step 14.
End of work. Go to step 15.
End of work. Go to step 16.
Replace the
End of work. HVPS. (REP
18.3)
No