Fip2.7 Clutch Assy Invert (Pl3.1.7) - Fuji Xerox DocuPrint M355df Service Manual

Chapter 2 Troubleshooting
2.3 Error Code FIP
FIP2.7 CLUTCH ASSY INVERT (PL3.1.7)
Step
Parts considered to be the cause
HOLDER ASSY DRIVE EXIT OUT (PL3.1.2)
HOLDER ASSY DRIVE EXIT IN (PL3.1.3)
CLUTCH ASSY INVERT (PL3.1.7)
PWBA MCU (PL18.2.2)
Check for foreign substances in the CLUTCH ASSY
INVERT Drive Section
1
Are there any foreign substances in the CLUTCH ASSY
INVERT Drive Section?
Check the shape of the HOLDER ASSY DRIVE EXIT OUT
and the HOLDER ASSY DRIVE EXIT IN
2
Is the HOLDER ASSY DRIVE EXIT OUT or the HOLDER
ASSY DRIVE EXIT IN damaged?
Check connector connection
Check the connection between the CLUTCH ASSY
3 INVERT and the PWBA MCU.
Is the CLUTCH ASSY INVERT (P/J17) connected
securely?
Check after replacing the CLUTCH ASSY INVERT
4 Replace the CLUTCH ASSY INVERT. (REP 3.3)
Does an error occur?
Check and Action
2-80
Yes No
Remove the
foreign sub- Go to Step 2.
stances
Replace the
HOLDER
ASSY DRIVE
EXIT OUT and Go to Step 3.
the HOLDER
ASSY DRIVE
EXIT IN
Securely con-
nect the
Go to Step 4. CLUTCH
ASSY INVERT
(P/J17)
Replace the
PWBA MCU. End of work.
(REP 18.2)