General Notes - Fuji Xerox DocuPrint M355df Service Manual

4.1.3 General notes

 [REP. X.Y "AAAAA"] at the top of the procedure means that the part name of an item which is
removed or replaced is "AAAAA".
 The string "(PL X.Y.Z)" suffixed to the part name in the procedure denotes that the part corre-
sponds to the plate (PL) "X.Y", item "Z" of [Parts list], and its shape and fitting position can be
checked in [Parts list].
 Steps marked as "[For *** specification]" are to be performed only on applicable models (Skip them
if not applicable).
 The string "(REP X.Y)" that appears in or at the end of the procedure denotes that the related
service procedure is described in [REP X.Y].
 Screws shown in the illustrations are to be unscrewed and removed using a Phillips head
(cross-slot) screwdriver, unless otherwise specified.
 Black arrows shown in the illustrations denote moving directions.
When numbers are assigned to these arrows, they refer to the order in the procedure.
 Refer to [7.1 Plug/Jack (P/J) Connector Locations] for the positions of connectors (P/J).
 The installation procedures are basically the reverse order of removal. There are notes at the
"Replacement" section for items which require special caution.
 Directional descriptions used in the procedures are defined as follows:
Front: Direction toward you when facing the front of the printer.
Rear: Direction opposite to the front when facing the front of the printer.
Left: Left-hand direction when facing the front of the printer.
Right: Right-hand direction when facing the front of the printer.
Chapter 4 Disassembly / Assembly and Adjustment
4-4
4.1 Preface