Mappwr-E: 5.0 V Current/Voltage Problem In Processor Subsystem - IBM iSeries Series Hardware Problem Analysis And Isolation

48. Power on the system. See Power on/off the system and logical partitions.
49. Did the system stop with the same error code as recorded in step 1 (See page 389)?
v Yes: The system clock card just reinserted is defective. Replace it. Return the system to its original
configuration. See Verify the repair.
This ends the procedure.
v No: Continue with the next step.
50. Have all the modules listed in step 42 (See page 391) been reinstalled?
v Yes: The symptom has changed. Return the system to its original configuration. See Verify the
repair.
This ends the procedure.
v No: Go to step 45 (See page 391).
51. Examine the amber logic-power LEDs of all installed processor subsystem DCAs.
52. Are all amber logic-power LEDs of all installed processor subsystem DCAs off?
v Yes: Continue with the next step.
v No: Replace the DCA that has the amber logic power LED that did not turn off. See symbolic FRU
"DCAPWR" on page 324.
53. Attention: Before replacing the system backplane, call your next level of support.
Replace the system backplane at location M1.
54. Power on the system. See Power on/off the system and logical partitions.
55. Did the system stop with the same error code as recorded in step 1 (See page 389)?
v Yes: Continue with the next step.
v No: The system backplane was defective. Return the system to its original configuration. See
Verify the repair.
This ends the procedure.
56. Power off the system. See Power on/off the system and logical partitions. Then, make sure all amber
logic-power LEDs of all installed processor subsystem DCAs are off.
57. Has the system backplane been replaced?
v Yes: Call your next level of support.
v No: Go to step 52 (See page 392).

MAPPWR-E: 5.0 V current/voltage problem in processor subsystem

For use by authorized service providers.
Note: Read the Danger and caution notices in the "MAPPWR" on page 364 introduction before performing
this procedure.
1. For future reference, record the error code and the location codes that sent you to this procedure.
2. Power off the system. See Power on/off the system and logical partitions. Then, examine the amber
logic-power LEDs of all installed processor subsystem DCAs.
3. Are all amber logic-power LEDs of all installed processor subsystem DCAs off?
v Yes: Continue with the next step.
v No: Replace the DCA that has the amber logic power LED that did not turn off. See symbolic FRU
"DCAPWR" on page 324.
4. Pull out the following books about 25 mm (1 inch), if present. See Models 870 and 890 - Memory
books and memory blanks.
v Memory book 0 at location M18
v Memory book 1 at location M24
v Memory book 2 at location M07
v Memory book 3 at location M02
392
iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation