Bus Pip Pcibus-Pip1 - IBM iSeries Series Hardware Problem Analysis And Isolation

v Yes: Call you next level of support.
This ends the procedure.
15. Exchange the card multi-adapter bridge's FRU at the card position that you determined for it. To
determine the remove and replace procedure for the multi-adapter bridge's FRU, locate the FRU's
card position in the FRU locations and failing items table for the frame type that you recorded. FRU
locations and failing items tables are in Locations and addresses.
16. Install all IOPs and IOAs in their original positions.
17. Power on the system or partition.
Does the SRC or failure that sent you to this procedure occur?
v No: Perform "Bus PIP verify - RA" on page 101.
This ends the procedure.
v Yes: Call your next level of support.
This ends the procedure.
Bus PIP PCIBUS-PIP1: For use by authorized service providers.
PCIBUS-PIP1: PCI Adapter Card Position Procedure.
1. If you were sent to this procedure with a specific Direct Select Address (DSA), then use it.
Otherwise, use the DSA in word 7 of the B6xx SRC, see "Breaking down the SRC" on page 63 (in
the Bus PIP overview topic) for help in locating the DSA.
2. Perform the following:
a. Record the bus number value, BBBB, in the DSA. See "DSA breakdown" on page 63 (in the Bus
PIP overview topic) for help in locating the BBBB value in the DSA. You must convert the BBBB
value to decimal.
b. Search for the decimal bus number in HSM or the System Configuration Listing to determine
which frame or I/O tower contains the failing item. From the Hardware Service Manager screen
select Logical Hardware Resources —> System Bus resources. Move the cursor to a system
bus object and select Display Detail. Do this for each bus until you find the bus on which you are
working.
c. Record the frame or tower type.
3. Record the Cc value in the DSA. See "DSA breakdown" on page 63 for help in locating the Cc value
in the DSA.
4. Is the Cc value greater than 00?
No: The multi-adapter bridge and the multi-adapter function number are not identified. Record that
v
the multi-adapter bridge is not identified in the DSA. The card slot cannot be identified using the
DSA. Go to step 8 (See page 99).
v Yes: Is the right-most character of the Cc value 'F'?
– No: Continue with the next step.
– Yes: Only the multi-adapter bridge number is identified. Record the multi-adapter bridge
number (the leftmost character of the Cc value) for later use. The card slot cannot be identified
using the DSA. Go to step 8 (See page 99).
5. Is SST/DST available?
No: Continue with the next step.
v
Yes: Go to step 12 (See page 100).
v
6. Use the "Card positions" on page 65 (located in the Bus PIP Overview topic) with the BBBB and Cc
values that you recorded to identify the card position. Use the card position table that matches the
frame or I/O tower type that you recorded.
7. Return to the procedure, Failing Item, or symbolic FRU that sent you here.
This ends the procedure.
8. Perform the following:
Analyze hardware problems
99