Sirgcfg - IBM iSeries Series Hardware Problem Analysis And Isolation

SIRGCFG

For use by authorized service providers.
An invalid configuration was detected on an HSL loop during IPL.
The four rightmost characters of word 4 in the SRC contains a Program Return Code (PRC) which
describes the problem detected. The leftmost four digits of word 7 in the SRC contains the loop number in
hexadecimal format. Convert the loop number to decimal format before comparing it to loop numbers
shown in HSM.
To determine the problem, find the PRC in the table below.
Note: The FRU description in the SAL may already contain a message that identifies the problem.
PRC (in word 4 of Problem identified
the SRC)
xxxx 0008 System serial number not set
xxxx 3200 Clustered system(s) on loop with SPD
migrated tower
xxxx 3201 Clustered systems on multiple HSL loops
xxxx 3202 Multiple SPD migrated towers detected
xxxx 3207 SPD migrated tower not on first HSL loop
xxxx 3212 NIC level does not support opticonnect
456
iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation
Corrective action
Set the serial number on the system unit.
(TM)
See the iSeries Service Functions
If the problem persists contact your next level
of support.
For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Remove clustered systems from the
loop with the migration tower.
Ensure all clustered systems are on the
same HSL loop.
For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Only one migration tower is supported
on a system. Remove the additional
migration towers.
For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Move the migration tower to the first
HSL loop. The first HSL loop is number 256
and attaches to ports A0 and A1 on the
network interface controller (NIC) card of the
system unit. The first HSL loop connects to
the system frame at HSL ports A0 and A1.
For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: See Corrective action for xxxx 3212
(See page 457) below.
.