Important Notes On Handling And Use - Roland DWX-50 Setup & Maintenance Manual

Important Notes on Handling and Use

This machine is a precision device. To ensure the full performance of this machine, be sure to
observe the following important points. Failure to observe these points may not only result in
loss of performance, but may also cause malfunction or breakdown.
This machine is a precision device.
 Handle carefully, and never subject the machine to impact or excessive force.
 Diligently keep clean of cutting waste.
 Use within the range of specifications.
 Never attempt to move the spindle head and rotary axis by hand with undue force.
 Never needlessly touch anywhere inside the machine except for locations specified in this manual.
Install in a suitable location.
 Install in a location that meets the specified conditions for temperature, relative humidity, and the like.
 Install in a quiet, stable location offering good operating conditions.
 Never install in out doors.
 Never use the machine in an environment where silicone substances (oil, grease, spray, etc.) are present.
Doing so may cause poor switch contact.
This machine becomes hot.
 Never cover the ventilation holes with cloth, tape, or anything else.
 Install in well-ventilated location.
This machine is exclusively for cutting modeling wax and zirconia, PMMA.
 Never cut any material other than modeling wax, zirconia, and PMMA.
About Tools
 The tip of the tool is breakable. Handle with care, being careful not to drop it.
24