Setting The Length Of Taper Bar; Setting The Number Of Stitches Of Taper Bar; Setting The Offset Of Taper Bar; Setting The Sewing Speed - JUKI MEB-3200 Instruction Manual

(8) Setting the length of taper bar

(9) Setting the number of stitches of taper bar

(10) Setting the offset of taper bar

(11) Setting the sewing speed

24
1) Set the length of taper bar with [RIGHT
2) In case of without taper bar, set the value to 0
mm. In case of with taper bar, the length can
be set 3 to 15 mm in the increments of 1 mm.
Length
Set the number of stitches of taper bar with [RIGHT
] key
Example) When the length of taper bar is equal
Set the offset amount with [RIGHT
[RIGHT
The offset amount can be set 0.5 mm to 2.0 mm in
the increments of 0.1 mm.
Offset amount
Set the sewing speed with [RIGHT
[RIGHT
The sewing speed can be set 400 sti/min to 2,200
sti/min in the increments of 100 sti/min.
Set the length of taper bar.
or [RIGHT ] key .
When the length of taper bar is changed,
the number of stitches of taper bar will
automatically change.
Set the number of stitches of taper bar.
or [RIGHT ] key
The number of stitches can be set to such
an extent of 0 to 20 stitches. The number
of stitches that can be set is limited by
the set value of the length of taper bar.
to 6 mm, the number of stitches is 2
to 12 stitches.
Set the offset amount from the center of
taper bar.
] key .
Set the sewing speed of the whole sewing.
] key .
] key
.
] key or
] key or