Subaru Legacy 2004 Service Manual page 1319

ENGINE (DIAGNOSTICS)
11.Clear Memory Mode
A: OPERATION
1. SUBARU SELECT MONITOR (NORMAL
MODE)
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
3) Press the [YES] key after the information of en-
gine type was displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {Memory Clear} and press the [YES] key.
5) When the "Done" and "Turn Ignition Switch OFF"
are shown on the display screen, turn the ignition
switch to OFF and then Subaru Select Monitor to
OFF.
NOTE:
For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
2. SUBARU SELECT MONITOR (OBD
MODE)
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
3) Press the [YES] key after the information of en-
gine type was displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the
{DTC Clear} and press the [YES] key.
6) When the "Perform Diagnostic Code(s) Clear?"
is shown on the screen, press the [YES] key.
7) Turn the ignition switch to OFF and then turn the
Subaru Select Monitor switch to OFF.
NOTE:
For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
Clear Memory Mode
MONITOR OPERATION
MONITOR OPERATION
EN(H4DOTC)(diag)-30