Subaru Legacy 2004 Service Manual page 1179

MECHANICAL
NOTE:
Be careful not to confuse the original combination
of piston, piston pin and cylinder.
(5)
(1) Cylinder block
(2) Rear oil seal
29) Remove the rear oil seal.
30) Remove the crankshaft together with connect-
ing rod.
31) Remove the crankshaft bearings from cylinder
block using a hammer handle.
NOTE:
Do not confuse the combination of crankshaft bear-
ings.
Press the bearing at the end opposite to locking lip.
32) Draw out each piston from cylinder block using
a wooden bar or hammer handle.
Cylinder Block
ST
ME-00142
(1)
(3)
(3) Crankshaft
(4) Crankshaft bearing
ME(H4DOTC)-68
24) Similarly remove the piston pins from #3 and #4
pistons.
25) Remove the bolts which connect cylinder block
on the side of #2 and #4 cylinders.
26) Back off the bolts which connect cylinder block
on the side of #1 and #3 cylinders two or three
turns.
27) Place the cylinder block to face the #1 and #3
cylinder side upward, and remove cylinder block
connecting bolts.
28) Separate the cylinder block (LH) and (RH).
NOTE:
When separating the cylinder block, do not allow
the connecting rod to fall and damage the cylinder
block.
(4)
(2)
(4)
(1)
(5)
(5) Piston
NOTE:
Be careful not to confuse the original combination
of piston and cylinder.
ME-00143