Subaru Legacy 2004 Service Manual page 1318

7) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
8) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
9) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
10) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
11) Press the [YES] key after the information of en-
gine type was displayed.
12) On the «Engine Diagnosis» screen, select the
{D Check} and press the [YES] key.
13) When the "Perform D Check?" is shown on the
screen, press the [YES] key.
14) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
• For details concerning DTCs, refer to the List of
Diagnostic Trouble Code (DTC).
<Ref. to EN(H4DOTC)(diag)-55, List of Diagnostic
Trouble Code (DTC).>
Inspection Mode
EN-02097
(A)
EN-00040
MONITOR OPERATION
EN(H4DOTC)(diag)-29
• Release the parking brake.
• The speed difference between front and rear
wheels may light either the ABS warning light, but
this indicates no malfunctions. When engine con-
trol diagnosis is finished, perform the ABS memory
clearance procedure of self-diagnosis function.
ENGINE (DIAGNOSTICS)