Subaru Legacy 2004 Service Manual page 1140

(2) Engine ground terminals
(3) Generator connector, terminal and A/C
compressor connector
(B)
(A) A/C compressor connector
(B) Generator connector and terminal
13) Disconnect the following hoses.
(1) Brake booster vacuum hose
(2) Heater inlet and outlet hoses
(3) Remove the hose between intake manifold
(A) and pressure regulator (B).
(A)
Engine Assembly
ME-00028
(A)
ME-00804
FU-01161
(B)
ME-00846
ME(H4DOTC)-31
14) Remove the power steering pump from brack-
et.
(1) Loosen the lock bolt and slider bolt, and re-
move the front side belt. <Ref. to ME(H4DOTC)-
39, FRONT SIDE BELT, REMOVAL, V-belt.>
(2) Disconnect the power steering switch con-
nector.
(3) Remove the power steering pump from en-
gine.
(4) Place the power steering pump on the right
side wheel apron.
15) Remove the linear motion mounting. <Ref. to
ME(H4DOTC)-37, REMOVAL,
Mounting.>
16) Lift-up the vehicle.
17) Remove the center exhaust pipe.
<Ref. to EX(H4DOTC)-6, REMOVAL, Center Ex-
haust Pipe.>
MECHANICAL
ME-00035
ME-00809
Linear Motion