Subaru Legacy 2004 Service Manual page 1271

LUBRICATION
6. Oil Pressure Switch
A: REMOVAL
1) Remove the collector cover.
2) Remove the generator from bracket.
<Ref. to SC(H4SO 2.0)-14, REMOVAL, Genera-
tor.>
3) Disconnect the terminal from oil pressure switch.
4) Remove the oil pressure switch.
B: INSTALLATION
1) Apply liquid gasket to the oil pressure switch
threads.
Liquid gasket:
THREE BOND 1324 (Part No. 004403007) or
equivalent
Oil Pressure Switch
2) Install the oil pressure switch onto engine block.
Tightening torque:
25 N
3) Connect the terminal to oil pressure switch.
LU-00036
4) Install the generator to bracket.
<Ref. to SC(H4SO 2.0)-14, INSTALLATION, Gen-
erator.>
5) Install the collector cover.
LU-00037
C: INSPECTION
Make sure oil does not leak or seep from where the
oil pressure switch is installed.
LU-00038
LU(H4DOTC)-16
#
m (2.5 kgf-m, 18.1 ft-lb)
LU-00037
LU-00036