Subaru Legacy 2004 Service Manual page 1071

24.Fuel Pump
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
• Reduce the fuel in the fuel tank to less than
3/4 beforehand. Be careful that fuel may spill
when the fuel is more than 3/4.
NOTE:
Fuel pump assembly consists of fuel pump and fuel
level sensor.
1) Release the fuel pressure.
<Ref. to FU(H4DOTC)-40, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.>
2) Open the fuel filler flap lid and remove the fuel
filler cap.
3) Disconnect the ground cable from battery.
4) Lift-up the vehicle.
5) Remove the fuel tank protector.
6) Set a container under the vehicle and remove
the drain plug from fuel tank to drain fuel from the
fuel tank.
7) Tighten the fuel drain plug.
NOTE:
Use a new gasket.
Tightening torque:
!
26 N m (2.65 kgf-m, 19.2 ft-lb)
8) Remove the rear seat.
9) Remove the service hole cover.
(1) Remove the bolt (A).
Fuel Pump
(2) Push the grommet (B) down under the body
and remove the service hole cover.
10) Disconnect the connector from fuel pump.
11) Disconnect the quick connector and then dis-
connect the fuel delivery hose, return hose and jet
pump hose. <Ref. to FU(H4DOTC)-56, REMOVAL,
Fuel Delivery, Return and Evaporation Lines.>
IN-00203
12) Remove the nuts which install the fuel pump
assembly onto fuel tank.
FU-01123
13) Take off the fuel pump assembly from fuel tank.
FU(H4DOTC)-49
FUEL INJECTION (FUEL SYSTEMS)
(A)
(B)
(B)
(A)
(A) Delivery hose
(B) Return hose
(C) Jet pump hose
(A)
FU-01124
FU-01125
(C)
FU-01140