Subaru Legacy 2004 Service Manual page 1142

25) Support the transmission with a garage jack.
CAUTION:
Doing this is very important because the trans-
mission lowers for its own weight. This work is
also of great importance for facilitating reinstal-
lation.
CAUTION:
Before moving the engine away from transmis-
sion, check to be sure no work has been over-
looked.
26) Separation of engine and transmission.
(1) Remove the starter. <Ref. to SC(H4SO 2.0)-
6, REMOVAL, Starter.>
(2) Install the ST to converter case.
ST 498277200 STOPPER SET
(3) Remove the bolts which hold upper side of
the transmission to engine.
27) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
Engine Assembly
ME-00048
ST
ME-00049
ME-00050
ME(H4DOTC)-33
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
28) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers to engine.
Tightening torque:
&
35 N m (3.6 kgf-m, 25.8 ft-lb)
2) Install the engine onto transmission.
Position the engine in engine compartment and
align it with transmission.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil pressure gauge, etc.
3) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
&
50 N m (5.1 kgf-m, 36.9 ft-lb)
4) Remove the lifting device and wire ropes.
5) Remove the garage jack.
MECHANICAL
ME-00050
LU-00222