Subaru Legacy 2004 Service Manual page 1144

NOTE:
Make sure the front cushion rubber mounting bolts
and locator are securely installed.
15) Install the center exhaust pipe.
<Ref. to EX(H4DOTC)-7, INSTALLATION, Center
Exhaust Pipe.>
16) Connect the oil flow control solenoid valve con-
nector and ground cable of exhaust side.
17) Lower the vehicle.
18) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
(4) Pressure regulator hose
19) Connect the following connectors and termi-
nals.
(1) Engine ground terminals
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connector
20) Install the air intake system.
Engine Assembly
(1) Install the intercooler. (DOHC turbo model)
<Ref. to IN(H4DOTC)-12, INSTALLATION, In-
tercooler.>
(2) Install the air cleaner element and air clean-
er case. <Ref. to IN(H4DOTC)-8, INSTALLA-
TION, Air Cleaner Case.>
21) Install the A/C pressure hoses.
NOTE:
Use new O-rings.
Tightening torque:
25 N
LU-00223
22) Install the radiator. <Ref. to CO(H4DOTC)-20,
INSTALLATION, Radiator.>
23) Install the coolant filler tank. (DOHC turbo mod-
el) <Ref. to CO(H4DOTC)-31, INSTALLATION,
Coolant Filler Tank.>
24) Install the window washer tank.
25) Install the battery to vehicle, and connect the
ME-00805
battery ground terminal.
26) Fill engine coolant.
<Ref. to CO(H4DOTC)-13, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
27) Charge the A/C system with refrigerant.
<Ref. to AC-21, PROCEDURE, Refrigerant Charg-
ing Procedure.>
28) Install the collector cover.
29) Remove the front hood stay, and close the front
hood.
30) Take off the vehicle from a lift.
ME-02092
C: INSPECTION
1) Check pipes and hoses are connected firmly.
2) Check the engine coolant and ATF are at speci-
fied levels.
ME(H4DOTC)-35
&
m (2.5 kgf-m, 18.1 ft-lb)
MECHANICAL
ME-00803