Subaru Legacy 2004 Service Manual page 1074

FUEL INJECTION (FUEL SYSTEMS)
26.Fuel Sub Level Sensor
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
• Reduce the fuel in the fuel tank to less than
3/4 beforehand. Be careful that fuel may spill
when the fuel is more than 3/4.
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle.
3) Set a container under the vehicle and remove
the drain plug from fuel tank to drain the fuel from
fuel tank.
4) Tighten the fuel drain plug.
Tightening torque:
!
26 N m (2.65 kgf-m, 19.2 ft-lb)
5) Remove the rear seat.
6) Remove the service hole cover.
(1) Remove the bolt (A).
(2) Push the grommet (B) down under the body
and remove the service hole cover.
(A)
Fuel Sub Level Sensor
IN-00203
FU-01123
(A)
(B)
FU-01126
FU(H4DOTC)-52
7) Disconnect the connector from fuel sub level
sensor.
8) Disconnect the quick connector and then discon-
nect the fuel delivery hose, return hose and jet
pump hose. <Ref. to FU(H4DOTC)-56, REMOVAL,
Fuel Delivery, Return and Evaporation Lines.>
9) Remove the bolts which install the fuel sub level
sensor on fuel tank.
(A)
(A) Jet pump hose
(B) Delivery hose
(C) Return hose
10) Remove the fuel sub level sensor.
FU-01143
(C)
(B)
FU-01144