Subaru Legacy 2004 Service Manual page 1047

6. Camshaft Position Sensor
A: REMOVAL
1. INTAKE SIDE
1) Remove the collector cover.
2) Disconnect the ground cable from battery.
3) Disconnect the connector from camshaft posi-
tion sensor RH.
4) Remove the camshaft position sensor RH from
the rear side of cylinder head.
5) Remove the camshaft position sensor LH in the
same procedure as RH.
2. EXHAUST SIDE
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle.
3) Remove the under cover.
Camshaft Position Sensor
4) Remove the sensor cover.
5) Disconnect the connector from camshaft posi-
tion sensor RH.
6) Remove the camshaft position sensor RH from
the lower side of cylinder head.
IN-00203
7) Remove the camshaft position sensor LH in the
same procedure as RH.
B: INSTALLATION
Install in the reverse order of removal.
FU-01185
Tightening torque:
IN-00203
FU(H4DOTC)-25
FUEL INJECTION (FUEL SYSTEMS)
!
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
FU-02156
FU-01186