Subaru Legacy 2004 Service Manual page 1057

16.Engine Control Module (ECM)
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the lower inner trim of passenger side.
<Ref. to EI-60, REMOVAL, Lower Inner Trim.>
3) Detach the floor mat of front passenger's seat.
4) Remove the protect cover.
5) Remove the nuts (A) which hold the ECM to
bracket.
6) Remove the clip (B) from bracket.
(A)
(A)
7) Disconnect the ECM connectors and take out
the ECM.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• When replacing the ECM, be careful not to
use the wrong spec. ECM to avoid any damage
to the fuel injection system.
• When replacing the ECM, be careful not to
damage the harnesses and connectors.
Engine Control Module (ECM)
IN-00203
FU-00896
(B)
FU-00897
FU(H4DOTC)-35
FUEL INJECTION (FUEL SYSTEMS)
Tightening torque:
!
5 N m (0.5 kgf-m, 3.6 ft-lb)