Subaru Legacy 2004 Service Manual page 1187

Cylinder Block
MECHANICAL
CAUTION:
• Be sure to use a new gasket.
• When installing the water pump, tighten the
bolts in two stages in alphabetical sequence as
shown in the figure.
(F)
(E)
(A)
(D)
(C)
(B)
ME-02094
31) Install the water by-pass pipe for heater.
32) Install the oil filter.
33) Install the water by-pass pipe between oil cool-
er and water pump.
34) Install the water pipe.
NOTE:
Always use new O-rings.
35) Install the cylinder head.
<Ref. to ME(H4DOTC)-59, INSTALLATION, Cylin-
der Head.>
36) Install the oil level gauge guide. (LH side)
37) Install the rocker cover.
38) Install the crank sprocket.
<Ref. to ME(H4DOTC)-52, INSTALLATION, Crank
Sprocket.>
39) Install the cam sprocket.
<Ref. to ME(H4DOTC)-51, INSTALLATION, Cam
Sprocket.>
40) Install the timing belt.
<Ref. to ME(H4DOTC)-44, INSTALLATION, Tim-
ing Belt.>
41) Install the timing belt cover.
<Ref. to ME(H4DOTC)-42, INSTALLATION, Tim-
ing Belt Cover.>
42) Install the crank pulley.
<Ref. to ME(H4DOTC)-41, INSTALLATION, Crank
Pulley.>
43) Install the generator and A/C compressor
brackets on cylinder head.
44) Install the V-belts. <Ref. to ME(H4DOTC)-39,
INSTALLATION, V-belt.>
45) Install the intake manifold.
<Ref. to FU(H4DOTC)-15, INSTALLATION, Intake
Manifold.>
ME(H4DOTC)-76