Subaru Legacy 2004 Service Manual page 1078

FUEL INJECTION (FUEL SYSTEMS)
29.Fuel Delivery, Return and Evaporation Lines
A: REMOVAL
1) Set the vehicle on a lift.
2) Release the fuel pressure. <Ref. to FU(H4DOTC)-40, RELEASING OF FUEL PRESSURE, PROCE-
DURE, Fuel.>
3) Open the fuel filler flap lid and remove the fuel filler cap.
4) Remove the floor mat. <Ref. to EI-73, REMOVAL, Floor Mat.>
5) Disconnect the fuel delivery pipes and hoses, and then disconnect the fuel return pipes and hoses, evap-
oration pipes and hoses.
6) In the engine compartment, disconnect the fuel
delivery hoses, return hoses and evaporation hose.
(C)
(A) Fuel delivery hose
(B) Return hose
(C) Evaporation hose
7) Lift-up the vehicle.
8) Remove the fuel tank. <Ref. to FU(H4DOTC)-
41, REMOVAL, Fuel Tank.>
Fuel Delivery, Return and Evaporation Lines
(A)
(B)
FU-01088
FU(H4DOTC)-56
9) Separate the quick connector of fuel line.
(1) Clean the pipe and connector, if they are
covered with dust.
(2) To prevent from damaging or entering for-
eign matter, wrap the pipes and connectors with
plastic bag etc.
(3) Hold the connector (A) and push retainer (B)
down.
(4) Pull out the connector (A) from retainer (B).
FU-01332
FU-01333