Subaru Legacy 2004 Service Manual page 1228

COOLING
(1) Radiator lower cushion
(2) Radiator
(3) Radiator upper cushion
(4) Radiator upper bracket
(5) Clamp
(6) Radiator inlet hose
(7) Engine coolant reservoir tank cap
(8) Overflow hose A
(9) Engine coolant reservoir tank
(10) Overflow pipe
(11) Radiator sub fan shroud
(12) Radiator main fan shroud
(13) Radiator sub fan ASSY
C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
General Description
(14) Radiator main fan ASSY
(15) ATF hose clamp
(16) ATF inlet hose A
(17) ATF outlet hose A
(18) ATF pipe
(19) ATF inlet hose B
(20) ATF outlet hose B
(21) Radiator outlet hose
(22) Radiator drain plug
(23) O-ring
(24) Engine coolant filler tank
(25) Radiator cap (Engine coolant filler
tank cap)
CO(H4DOTC)-6
(26) Engine overflow hose
(27) Engine air breather hose
(28) Radiator lower bracket
(29) Overflow hose B
(30) Heat shield cover
%
Tightening torque: N m (kgf-m, ft-lb)
T1: 3.4 (0.35, 2.5)
T2: 4.4 (0.45, 3.3)
T3: 7.5 (0.76, 5.5)
T4: 18 (1.8, 13.0)