Subaru Legacy 2004 Service Manual page 1249

9. Radiator Sub Fan and Fan
Motor
A: REMOVAL
1) Remove the collector cover.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect the sub fan motor connector (B).
6) Remove the heat shield cover from radiator.
7) Drain the coolant about 1 2 (1.06 US qt, 0.88
Imp qt). <Ref. to CO(H4DOTC)-13, DRAINING OF
ENGINE COOLANT, REPLACEMENT, Engine
Coolant.>
8) Remove the ATF hose from the clip of radiator
sub fan motor assembly.
9) Lower the vehicle.
10) Remove the air intake duct.
11) Disconnect the over flow hose.
12) Remove the over flow pipe.
13) Remove the reservoir
CO(H4DOTC)-30, REMOVAL, Reservoir Tank.>
Radiator Sub Fan and Fan Motor
IN-00203
(B)
CO-00252
CO-00250
tank. <Ref. to
CO(H4DOTC)-27
14) Remove the mounting bolts of radiator sub fan
motor assembly.
15) Disconnect the radiator inlet hose (A) from ra-
diator.
16) Remove the hood stay holder (B).
17) Remove the radiator sub fan motor assembly
from vehicle.
B: INSTALLATION
1) Install the radiator sub fan motor assembly to ve-
hicle.
2) Connect the radiator inlet hose (A) to radiator.
3) Install the hood stay holder (B).
COOLING
CO-00292
(A)
(B)
CO-00255
(A)
(B)
CO-00255