Subaru Legacy 2004 Service Manual page 1159

MECHANICAL
3) Installation of timing belt:
Align the alignment mark on the timing belt with marks on the sprockets in the alphabetical order shown in
the figure. While aligning marks, position the timing belt properly.
CAUTION:
• Disengagement of more than one timing belt tooth may result in interference between valve and
piston.
• Ensure the belt's rotating direction is correct.
(3)
RH-IN
RH-EX
(E)
(1) Arrow mark
(2) Timing belt
(3) 28 tooth length
4) Install the belt idlers.
Tightening torque:
!
39 N m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
Make sure that the marks on the timing belt and
sprockets are aligned.
5) After ensuring that the marks on the timing belt
and sprockets are aligned, remove the stopper pin
from tensioner adjuster.
Timing Belt
(1)
(4)
(D)
(7)
(4) 54.5 tooth length
(5) 51 tooth length
(6) 28 tooth length
ME-00090
ME(H4DOTC)-48
(5)
(B)
(A)
(7) Install it in the end
6) Install the timing belt guide.
(1) Temporarily tighten the bolts.
(2) Check and adjust the clearance between
timing belt and timing belt guide.
Clearance:
" "
1.0 0.5 mm (0.039
(3) Tighten the bolt.
(2)
(6)
LH-IN
LH-EX
(C)
ME-00089
0.020 in)
ME-00091