Subaru Legacy 2004 Service Manual page 1143

MECHANICAL
6) Install the pitching stopper.
Tightening torque:
&
T1: 50 N m (5.1 kgf-m, 36.9 ft-lb)
&
T2: 58 N m (5.9 kgf-m, 43 ft-lb)
T2
7) Remove the ST from converter case.
NOTE:
Be careful not to drop the ST into the converter
case when removing the ST.
ST 498277200 STOPPER SET
8) Install the starter. <Ref. to SC(H4SO 2.0)-6, IN-
STALLATION, Starter.>
9) Install the torque converter clutch to drive plate.
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
CAUTION:
Be careful not to drop bolts into the torque con-
verter clutch housing.
ST 499977400 CRANK PULLEY WRENCH
Tightening torque:
&
25 N m (2.5 kgf-m, 18.1 ft-lb)
10) Install the linear motion mounting. <Ref. to
ME(H4DOTC)-37, INSTALLATION, Linear Motion
Mounting.>
11) Install the power steering pump on bracket.
Engine Assembly
T1
LU-00224
ME-00044
ME(H4DOTC)-34
(1) Install the power steering pump.
Tightening torque:
&
20.1 N m (2.05 kgf-m, 14.8 ft-lb)
(2) Connect the power steering switch connec-
tor.
(3) Install the front side belt and adjust it. <Ref.
to ME(H4DOTC)-39, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
12) Lift-up the vehicle.
13) Tighten the nuts which hold lower side of the
transmission to engine.
Tightening torque:
&
50 N m (5.1 kgf-m, 36.9 ft-lb)
14) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
&
85 N m (8.7 kgf-m, 62.7 ft-lb)
ME-00037
ME-00035
ME-00040