Subaru Legacy 2004 Service Manual page 1259

Hide thumbs Also See for Legacy 2004:

Table of Contents

• Wear work clothing, including a cap, protective

goggles and protective shoes during operation.

• Remove contamination including dirt and corro-

sion before removal, installation or disassembly.

• Keep the disassembled parts in order and pro-

tect them from dust and dirt.

• Before removal, installation or disassembly, be

sure to clarify the failure. Avoid unnecessary re-

moval, installation, disassembly and replacement.

D: PREPARATION TOOL

1. SPECIAL TOOL

ILLUSTRATION

ST-499977400

ST-499587100

ST18332AA000

General Description

CRANK PULLEY

LU(H4DOTC)-4

• Be careful not to burn yourself, because each

part on the vehicle is hot after running.

• Be sure to tighten fasteners including bolts and

nuts to the specified torque.

• Place shop jacks or rigid racks at the specified

• Before disconnecting electrical connectors of

sensors or units, be sure to disconnect the ground

cable from battery.

Used for stopping rotation of crank pulley when

removing and tightening crank pulley bolt.

Used for installing oil seal into oil pump.

Used for removing and installing oil filter. (Outer

diameter: 68 mm (2.68 in))

Chapters

Table of Contents