Activating System Programming - Siemens HiPath 1100 Programming Manual

Step by Step
Description
Fax/DID - Virtual Message Ports
USB/CAPI line
Substitution for * and #

Activating System Programming

Lift the handset at the programmer's extension slot.
System programming can only be executed us-
ing the system's first extension slot (default ex-
tension 11) with an analog extension (MF), a KS-
type system telephone or an optiPoint system
telephone. Programming cannot be done simul-
taneously on two extensions.
Enter the code for activating system programming.
9 5
*
Enter the system password (default is 31994 - Changing
system password
You will hear a tone indicating that you have now ac-
cessed the Programming Mode.
Audible Tones in the Programming Mode (Brazil)
• Correct entry: 1 beep/confirmation tone.
• Incorrect entry: 3 beeps. The program will then re-
vert back to the initial screen of the Programming
Mode.
• After completing the programming steps, the sys-
tem responds with a confirmation tone and finalizes
the setting configuration. The program will then re-
vert back to the initial screen of the Programming
Mode.
Canceling a Setting's Configuration
• You can cancel the configuration of a setting at any
time by pressing the "#" key. The program will then
revert back to the initial screen of the Programming
Mode.
HiPath 1120 HiPath 1150 HiPath 1190
740 to 743
10
75 and 76 (accordingly)
page 107).
Programming Mode
100
19