Dial Tone Detection - Siemens HiPath 1100 Programming Manual

Programming an External Line
Step by Step
48

Dial Tone Detection

When activated, this feature checks to see if there is a
dial tone. If activated for an external analog line, the se-
lected number is stored. The number is sent to an ex-
ternal line once the extension making the call receives
an external line dial tone from its local carrier. If the line
does not provide a dialing tone (line not installed), it is
automatically blocked by the system. With MF tele-
phones the number dialed will be transmitted to the ex-
ternal line approximately 4 to 5 seconds after the last
digit was dialed (1A dialing).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 0
Enter a number for an external analog line (e.g., 801).
ou
Activate/Deactivate Dial Tone Detection for an external
#
*
analog line:
*
#
Enter the number for the next external line available.
or
# Press this key.
Initial state for Programming Mode.
= To activate (default)
= To deactivate