Elapsed Timeout For External-To-External Connection; Configuring A Timeout For An External-To-External Connection - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
...
0 0 0 0
88
Elapsed timeout for external-to-exter-
nal connection
It allows configuring a timeout between two external
calls when no other extension is involved in the call.
The user hears a warning tone before the timeout
expires. A warning tone is sent 10 seconds before the
end of the timeout. When the call is between two exter-
nal lines with no internal extension involved, the call is
terminated once the timeout elapses.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2
1 8
or Activate/Deactivate the timeout:
* #
*
#
Initial state for Programming Mode.
Configuring a Timeout for an External-
to-External Connection
It allows configuring a timeout between two external
calls when no other extension is involved in the call. Call
timeout can be set from 1 minute to 24 hours (default
setting is 1 hours).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 1 9
Enter a timeout for call connection (0000 to 1440, in 1-
1 4 4 0
minute increments).
Initial state for Programming Mode.
= To activate
= To deactivate (default)