Programming Mode; Numbering Plan - Siemens HiPath 1100 Programming Manual

Programming Mode

Step by Step
Description
External Line
Extension, including S
Groups of External Lines
Call Groups (CG)
Hunt Groups (HG)
UCD Subscriber Groups
Carrier
EVM - Default internal number
EVM - Message Ports
EVM - Virtual Ports
18
Programming Mode
You can change the default settings of the HiPath 1100
to fit your needs. A MF-type or System Telephone can
be used for this purpose, or a PC with the HiPath 1100
Manager administration software installed
( page 173).
The instructions that follow refer to the factory
default settings.

Numbering Plan

The Numbering Plan is configured based on the mod-
ules that are detected by the system.
• For HiPath 1120:
1. Motherboard
2. S Module
0
3. Analog modules/UP
• For HiPath 1150:
1. TME1 Module
2. Motherboard
3. S Module
0
4. Analog modules/UP
• For HiPath 1190:
1. TME1 Module
2. Analog modules/UP
3. S Module
0
0
Module
0/E
Module
0/E
Module
0/E
HiPath 1120 HiPath 1150 HiPath 1190
801 to 808 801 to 832
11 to 30 11 to 60
610 to 645
0 , 890 to 899
770 to 779
780 to 789
790 to 799
7491 and 7492
744 to 747
801 to 845
101 to 240
9
790