Pulses For Call Charges On An Analog Extension; Timer For Outgoing External Calls - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
84
Pulses for Call Charges on an Analog Ex-
tension
This sends pulses to be charged for calls on an analog
extension (12kHz/16kHz). With this feature, an exten-
sion's telephone set can display the number of pulses
or the amount charged for the call.
Required: Telephone with a display and Programming
Mode activated (*95 31994).
Enter the code for programming.
0 4 1
Enter the analog extension number (e.g., 11/101).
or
Activate/Deactivate transmission of billing pulses:
* #
= To activate
*
= To deactivate (default)
#
Enter the next analog extension number.
or
Press this key.
#
Initial state for Programming Mode.

Timer for Outgoing External Calls

This setting specifies a maximum time for the duration
of an outgoing external call for each extension.
The time count starts upon connection of a call and it
never restarts while the call is in progress (e.g., when
there is a transfer). Once the time expires, the call is ter-
minated.
In the default configuration the maximum time for the
duration of outgoing external calls is 180 seconds for all
extensions.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 7
Enter the extension number (e.g. 11/101).
Please refer to the documentation provided with
the telephone set connected to the extension
slot to find out if a billing indication is supported
and which reception mode is used.