Flash Duration On An Analog Line; Reseizure Time For An External Line - Siemens HiPath 1100 Programming Manual

Step by Step
...
0 5
...
0 5

Flash Duration on an Analog Line

The duration of the Flash signal that is sent by the sys-
tem to each external analog line can be configured indi-
vidually. Flash signal duration depends on the specific
setting for each country.
If the country configuration(
external line connection (
Flash Duration will automatically reset to the default val-
ue.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 1 8
Enter a number for an external analog line (e.g., 801).
Enter the length of time (05 to 99) for the Flash signal.
9 9
Take into account that 05 = 50 ms ... 99 = 990 ms.
Enter the next number for the external analog line.
or
Press this key.
#
Initial state for Programming Mode.

Reseizure time for an external line

There is a timeout for reseizing an external line. Once an
outgoing call has ended the line will remain blocked dur-
ing the specified timeout.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 2 9
Enter the length of time (05 to 99) for the Flash signal,
9 9
where 05 = 500 ms (default) to 99 = 9900 ms.
Initial state for Programming Mode.
When a line is programmed directly on the sys-
tem, default Flash duration is 240ms. When a
line is programmed from a different system, de-
fault Flash duration is 100ms.
Valid only for external analog lines.
Programming an External Line
page 21) or the type of
page 49) is changed, the
45