Timeout For A Second Attendant To Answer A Call On; An External Analog Line - Siemens HiPath 1100 Programming Manual

Programming an External Line
Step by Step
0 1
52
Press this key.
#
Initial state for Programming Mode.
Timeout for a Second Attendant to an-
swer a call on

an external analog line

This consists of a time period (in seconds) during which
an incoming call rings at the First Attendant of an exter-
nal line. If the call is not answered within the specified
amount of time, it will be routed to the Second Atten-
dant (
The default configuration is set to 30 seconds.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 8 3
Enter a number for an external analog line (e.g., 801).
...
2 0 Enter the activation timeout (01 to 20 in 5-second incre-
ments) where 00 = 0 seconds... 06 = 30 seconds (de-
fault), etc.
Initial state for Programming Mode.
In the case of an external ISDN line, if the setting
is configured as Absent two interfaces will be
disabled.
For digital lines (E1 CAS/S2) you must also pro-
gram a TME2 Module1 using the E1 Trunk Man-
ager (E1 CAS) and the S2M Maintenance (S2) ap-
plication.
page 25).