Waiting Message Before Signaling A Ucd Call; Minimum Time For Call Waiting Message In A Ucd Queue - Siemens HiPath 1100 Programming Manual

Step by Step
*
0 0 ...

Waiting Message before Signaling a UCD Call

This feature allows you to connect a call waiting mes-
sage for incoming calls before they ring at a UCD exten-
sion.
Required: Programming Mode must be active (*95
31994).
0 3 2 Enter the code for programming.
Enter the UCD Subscriber Group number (790 to 799).
or
Activate/Deactivate call waiting message:
#
* = To activate
= To deactivate (default)
#
Enter the next UCD Subscriber Group number.
or
Press this key.
#
Initial state for Programming Mode.
Minimum Time for Call Waiting Message in a
UCD Queue
This setting specifies a minimum length of time until a
message is played for calls waiting in a UCD Queue.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 3 3
Enter the UCD Subscriber Group number (790 to 799).
9 9 Enter the minimum amount of time for playing the an-
nouncement (or music) (00 to 99 in 5-second incre-
ments) where 00 = 0 seconds (default)... 01 = 5 sec-
onds (default) ... 06 = 30 seconds, etc.
Enter the next UCD Subscriber Group number.
or
# Press this key.
Initial state for Programming Mode.
This feature works only when Time in a UCD
Queue is enabled (code 031).
Programming an Extension
63