Hunt Groups (Hg) - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
64

Hunt Groups (HG)

A Hunt Group is a group of extensions for answering
calls directed to a specific number identifying the
group. When an extension does not answer an internal
or external call within a specified period of time, the call
will ring consecutively at the extensions that are avail-
able within the group. When there is no signal, the ex-
tension may disconnect from the Hunt Group.
Extensions can be grouped in a maximum of 10 Hunt
Groups (780 to 789). The default setting assigns no ex-
tensions to Hunt Groups.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 2 1
Enter the Hunt Group number (780 to 789).
Enter the extension numbers (e.g., 11/101) to be includ-
ed in the Hunt Group.
Press this key.
#
Initial state for Programming Mode.
Deleting extensions from Hunt Groups
Required: Programming Mode must be active (*95
31994).
0 2 1 Enter the code for programming.
Enter the Hunt Group number (780 to 789)
Delete all extensions in the Hunt Group.
*
Press this key.
#
Initial state for Programming Mode.
This feature works only on digital lines.