Entrance Telephone; Configuring An Entrance Telephone - Siemens HiPath 1100 Programming Manual

Step by Step
1
1

Entrance Telephone

Configuring an Entrance Telephone

With the HiPath 1100 you can connect up to four En-
trance Telephones in extension slots. Each Entrance
Telephone must be individually activated in the system.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 1 5
...
Select a slot for the Entrance Telephone extension
4
(1 to 4).
Enter the analog extension number (e.g., 12/102) to be
enabled as an Entrance Telephone.
Repeat these steps for any additional slot.
or
Press this key.
#
Initial state for Programming Mode.
Deleting an Entrance Telephone Assignment
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 1 5
...
4 Enter the slot to be deleted.
Delete the assignment of the Entrance Telephone to
*
the extension.
Enter the next slot.
or
Press this key.
#
Initial state for Programming Mode.
1. By default no slot is set as an Entrance Tele-
phone.
2. Each TFE Interface Module can be connect-
ed to one Entrance Telephone only.
3. Each TFE Interface Module serves as an in-
terface for an Entrance Telephone or or Pag-
er. To provide these two interfaces two mod-
ules must be used.
Entrance Telephone
119