Siemens HiPath 1100 Programming Manual page 26

Main Configurations
Step by Step
26
Enter the extension numbers (e.g., 11/101) or call
groups that should signal when receiving calls from the
specified external line (up to 10 extensions or 1 group).
# Press this key.
Initial state for Programming Mode.
To assign an extension as an attendant for different
lines, repeat the programming steps.
Deleting Attendants for an External Line
Required: Programming Mode must be active (*95
31994).
1 4 2 Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
Select the period of the day for answering calls:
1 = Day Service
= Night Service
2
= Second Attendant - Day
3
4 = Second Attendant - Night
The selected line attendant will be deleted.
*
Press this key.
#
Initial state for Programming Mode.
If an extension is connected to a Door Opener, it
cannot be configured as an attendant.
Within a Subscriber Group an incoming call rings
at the first extension available, according to the
call distribution plan configured for the UCD Sub-
scriber Group.
When there is no First Attendant configured, the
call is forwarded to the Overflow extension. If an
Overflow extension has not been configured, the
call is terminated and does not ring at any exten-
sion, neither can it be captured. When this oc-
curs, the system waits until the external line is
made available by the Carrier.