Exiting Programming Mode; Main Configurations; Language - Siemens HiPath 1100 Programming Manual

Main Configurations

Step by Step
20
Exiting a Setting's Configuration
There are three different ways to finalize the configura-
tion of a setting. After configuring the setting, you will
be returned to the initial screen of the Programming
Mode.
• After a setting is configured, the Programming
Mode is automatically exited.
• After configuring a setting, press the # key.
• After configuring a setting, wait approximately 5
seconds.
If no code or setting is entered, the system will continue
to wait for one or assume a "null entry" then proceed to
the next programming step. The next step will depend
on the code that was selected.

Exiting Programming Mode

After completing the configuration of a setting, you will
be returned to the initial screen of the Programming
Mode. Follow these steps to exit the Programming
Mode:
Replace the handset.
Main Configurations
Some settings may be modified right from the begin-
ning. In most cases, however, we recommend using
the default settings. If you need to change any settings,
see the following chapters:

Language

Select the desired language for displaying messages on
the system telephones. This field is not going to be
used automatically due to the selection specified in the
Country field. When Language setting is changed,
Country settings are not changed. It is possible, there-
fore, to select a country with a different default lan-
guage. Example: Country: Brazil, Language: English.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 4