External-To-External Transfer - Siemens HiPath 1100 Programming Manual

Step by Step
*

External-to-External Transfer

This feature allows a specified extension to transfer an
external call (incoming or outgoing) to another external
call.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 9
1
Enter the extension number (e.g. 11/101).
or
Activate/Deactivate Transfer:
#
* = To activate
= To deactivate (default)
#
Press this key.
#
Initial state for Programming Mode.
An External-to-External transfer can only be made
when at least one of the lines is a digital line and
one of the calls is outgoing.
An External-to-External Transfer over an analog
line is terminated in the following three situations:
• Elapsed timeout for external-to-external con-
nection (Code 218)
• When a busy signal is detected
• Type of Answering Signal (Code 158).
Programming an Extension
87