Permission Lists - Siemens HiPath 1100 Programming Manual

Main Configurations
Step by Step
or
4
0 1
Wait 5 seconds
or
4
0 1
Wait 5 seconds If no new number is entered after 5 seconds, the con-
30

Permission Lists

There are three Permission Lists that can be configured
with different telephone numbers and individual exten-
sion prefix combinations (enter the number without the
external access code).
• Permission List 1 (COS 4) with 4 entries
• Permission List 2 (COS 5) with 10 entries
• Permission List 3 (COS 6) with 25 entries
In addition to speed-dial numbers, the telephones con-
figured for Outward-Restricted Trunk Access (with Per-
mission List) can only dial numbers that start with these
combinations. When any other number is dialed, the
phone answers with a busy signal.
The Permission List already contains some combina-
tions. These can be deleted if so desired.
Required: Programming Mode must be active (*95
31994).
1 2 4 Enter the code for programming.
or
Enter the number for the Permission List.
5 6
...
Enter the phonebook entry number for the number to
2 5
be allowed access.
Enter the number that will be allowed access (up to 16
digits).
Warning: Enter the number without the external access
code.
Wait for a confirmation tone.
Initial state for Programming Mode.
Deleting numbers from a Permission List
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 2 4
or
Enter the number for the Permission List.
5 6
...
Enter the list entry number of the number to be delet-
2 5
ed.
tent of that entry is removed.
Initial state for Programming Mode.
To change an allowed number just enter its list
entry number and the new number.