Configuring The System Specifically For The Client; Table Of The System's Programming Codes; Table 7-1 Configuration Procedure Summary - Siemens hipath 1100 Service Manual

For internal distribution only

7 Configuring the System Specifically for the Client

Procedure Summary
Table 7-1 Configuration procedure summary
Step System Telephone/Standard MF Telephone
1. System programming can only be executed using the sys-
tem's first extension slot (analog extension (MF) or system
telephone).
2. Programming Mode: *95 + PASSWORD (default: 31994). Configure CommServer.
3. Valid parameter or slot: beep (Brazil).
When an incorrect setting is entered: 3 beeps (Brazil).
4.
5. When completed: 1 beep (Brazil).
6. End programming: press "#" key or replace handset.

7.1 Table of the System's Programming Codes

The Numbering Plan is configured based on the modules detected by the system.
For the HiPath 1120:
●
Motherboard
S0 Module
Analog Modules
For the HiPath 1130/1150:
●
TME1 Module 1
Motherboard
S0 Module
Analog Modules
For the HiPath 1190:
●
Analog Modules
TME1 Module 1
S0 Module
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Table of the System's Programming Codes
HiPath 1100 Manager
Connect the PC to the sys-
tem.
Start the program.
System data are automati-
cally imported.
Start programming.
Export the new configura-
tion settings.
7-1