System Programming In Interactive Mode - Siemens Hicom 100 E Service Manual

7.5

System programming in interactive mode

Hicom 100E is programmed at the optiset connected to the U
number 11 or 12) after starting access-protected system administration. See Section 7.6.1
It is advisable to use an optiset memory telephone. Due to the improved user interface for ter-
minals with a two-line display, it is also possible to use an optiset base, optiset E standard or
an optiset E advanced.
The offered menus can be addressed via a number of keys. Branching is implemented as you
move to higher-level or lower-level menus.
You must always acknowledge error messages! If an error message is issued because a code
has already been assigned, the expert code appears at the beginning of the second line of the
display. This code can be used to branch to the appropriate section of the menu.
The functions assigned to function keys F1 to F8 appear in the menu.
General key functions:
+ -
scroll down scroll up
F2 continue/go to next code
F3 delete
F7 previous/quit
F8 return to main menu
Simply follow the user prompts; the system will always inform you of available and unavailable
(error messages) options and will recommend corrective measures using expert mode (branch
address to collision entry found).
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
Administration and maintenance
System programming in interactive mode
user PEN 01 or 02 (internal
P0/E
7-7