+/-10V Analog Speed Setpoint Value As Signal Source - Parker Compax3 Operating Instructions Manual

Setting up Compax3
Travel Distance per Master Axis
Z1
*
revolution (M_Units/rev)
MD =
Travel Distance per Master Axis
N1
revolution - Denominator
Travel path per revolution slave axis
Z2
*
numerator
SD =
N
Travel path per revolution slave axis
2
denominator
MD:
Feed of the master axis
SD:
Feed of the slave axis
156
Detailed structure image
with:
4.2.2.3

+/-10V analog speed setpoint value as signal source

Via Analogkanal 0 (X11/9 und X11/11) the speed of the master is read in.
From this value a position is internally derived, from which then the motion of the
drive is derived with reference to the transmission ratio.
Without limitation effect applies:
Velocity of the master * (Gearing numerator / gearing denominator) = velocity of
the slave
Signal processing of the analog input 0
X11/9 +
X11/11-
B: Continuative structure image (see on page 238)
The reference to the master is established with the velocity at 10V.
If required the direction of rotation of the master axis read in can be changed.
192-120113 N08 C3I12T11 - December 2010
Entry in the "configuration
of the signal source"
wizard
Entry in the "configuration
of the signal source"
wizard
Analog 0
Actual
value
+
monitoring
170.2
170.4
C3I12T11
Precise
interpolation
B
T
config
685.3
170.3