Test Commissioning Of A Compax3 Axis; Selection Of The Supply Voltage Used; Motor Selection; In This Chapter You Can Read About: Test Commissioning Of A Compax3 Axis - Parker Compax3 Operating Instructions Manual

Parker EME
4.1.1.

Test commissioning of a Compax3 axis

4.1.2.

Selection of the supply voltage used

4.1.3.

Motor selection

In the device online help, we show you at this place an animation of a test
setup with the aim to move an unloaded motor.
Simple and independent of the Compax3 device variant*

Without overhead for configuration

Without special knowledge in programming

* for device specific functions, please refer to the corresponding device description.
Due to continuous optimization, individual monitor displays may have changed.
This does however hardly influence the general proceeding.
Please select the mains voltage for the operation of Compax3.
This influences the choice of motors available.
The selection of motors can be broken down into:
Motors that were purchased in Europe and

Motors that were purchased in the USA.

You will find non-standard motors under "Additional motors" and

under "User-defined motors" you can select motors set up with the C3

MotorManager.
For motors with holding brake SMHA or MHA brake delay times can be entered.
For this see Brake delay times (see on page 287).
Pleas note the following equivalence that applies regarding terms concerning
Rotary motors / linear motors

Revolutions ≡ Pitch

Rotation speed (velocity)≡ Speed

Torque ≡ Power

Moment of inertia ≡ Load

Notes on direct drives (see on page 328) (Linear and Torque - Motors)
192-120113 N08 C3I12T11 - December 2010
linear motors:
Setting up Compax3
99