Conditions Of Utilization For Ul Certification Compax3M - Parker Compax3 Operating Instructions Manual

Parker EME
1.7.3.

Conditions of utilization for UL certification Compax3M

UL-approval for PSUP/Compax3M
conform to UL:
Certified
The UL certification is documented
by a "UL" logo on the device (type
specification plate).
Conditions of utilization
The devices are only to be installed in a degree of contamination 2 environment

(maximum).
The devices must be appropriately protected (e.g. by a switching cabinet).

Tightening torque of the field wiring terminals ( green Phoenix plugs)

Device X40: Ballast resistor
0.5 Nm (4.43Lb.in)
PSUP10
0.5 Nm (4.43Lb.in)
PSUP20
UL approval in preparation
PSUP30
Device X43: Motor connector
0.5Nm (4.43Lb.in)
C3M050-150
1.2Nm (10.62Lb.in)
C3M300
Temperature rating of field installed conductors shall be at least 60°C Use copper

lines only
Please use the cables described in the accessories chapter (see on page 323,
see on page 324), they feature a temperature rating of at least 60°C.
Maximum Surrounding Air Temperature: 40°C.

Suitable for use on a circuit capable of delivering not more than 5000 rms

symmetrical amperes and 480 volts maximum.
Caution!
Danger of electric shock.
Discharge time of the bus capacitor is 10 minutes.
The drive provides internal motor overload protection.

This must be set so that 200% of the motor nominal current are not exceeded.
Cable cross-sections

Mains input: corresponding to the recommended fuses.

Motor cable: corresponding to the Nominal output currents (see on page 375,

see on page 376)
Maximum cross-section limited by the terminals mm

Line cross-sections of the power connections (on the device bottoms)
Compax3 device: Cross-section: Minimum... Maximum [with conductor sleeve]
M050, M100, M150
0.25 ... 4 mm
M300
0.5 ... 6 mm
PSUP10
Mains supply: 0.5 ... 6 mm
Braking resistor: 0.25 ... 4 mm
PSUP20 & PSUP30
Mains supply: 0.5 ... 16 mm
Braking resistor: 0.25 ... 4 mm
192-120113 N08 C3I12T11 - December 2010
according to UL508C

E-File_No.: E235342

X41: Mains connector
1.2 Nm (10.62Lb.in)
1.7 Nm (15Lb.in)
X15: Temperature monitoring
0.22Nm (1.95Lb.in)
0.22Nm (1.95Lb.in)
2
/ AWG
2
(AWG: 23 ... 11)
2 (AWG: 20 ... 10)
2
(AWG: 20 ... 10)
2 (AWG: 23 ... 11)
2
(AWG: 20 ... 6)
2
(AWG: 23 ... 11)
Introduction
X9: 24VDC
1.2 Nm
(10.62Lb.in)
1.2 Nm
(10.62Lb.in)
23