User Interface - Parker Compax3 Operating Instructions Manual

Setting up Compax3
166
Cursor modes -functions
Depending on the operating mode, different cursor functions are available within
the osci monitor.
The functions can be changed sequentially by pressing on the right mouse button.
Cursor Symbol Function
Set Marker 1
the measurement values of the active channel as well as the Y
difference to marker 2 are displayed
Set Marker 2
Delete and hide marker
Move offset of the active channel.
The yellow symbol indicates that the scrolling is active.
Set trigger level and pretrigger
In the ROLL operating mode, marker functions and set trigger level positions are
not available.
4.4.2.2

User interface

In this chapter you can read about:
Oscilloscope operating mode switch: .............................................................................
Setting the time basis XDIV ...........................................................................................
Settings for channels 1..4 ..............................................................................................
Trigger settings ..............................................................................................................
Special functions ...........................................................................................................
192-120113 N08 C3I12T11 - December 2010
C3I12T11